In recent years, people like to cover the floor with ceramic tiles, that is, both the floor and the wall are covered with ceramic tiles. In fact, the effect is quite good, but some people like it and some people don’t. So let’s focus on it today. Let’s talk about the topic of tile background wall! Take a look at its design techniques and key points?
When decorating a house, everyone will consider the background wall of the living room. Because they do not understand the design, many people do not know how to design it reasonably. In order to design the TV background wall more beautifully, everyone needs to know how to design it. So, let’s take a look together next!
What are the design techniques for ceramic tile background walls?
1. Before paving, you must find an empty space and splice the patterns together according to the numbers on the bottom of the bricks. The products must be placed vertically before and after unpacking, avoid laying flat.
2. Unpack the package, and when moving a single piece, be careful not to scratch the patterns on other brick surfaces with the corners of the bricks. When moving single pieces, try to avoid friction between the two bricks, even if the surface is covered with a protective film. Before paving, check the firmness of the wall according to the specific adhesion method and adhesive requirements. If the wall does not reach the strength, it needs to be removed and reinforced. Do not remove the protective film before installation.
3. In order to avoid scratching the brick pattern, when applying adhesive on the back of the product, place the front of the product on a relatively soft material such as foam, paper or cloth. When paving the product, you need to use a wooden board to pad the surface. Do not directly tap the brick surface with paving tools. .Do not use too much force when filling to avoid scratching the screen of the product.
4. It is recommended not to peel off the protective film after all the adhesion is completed. Wait until the decoration of the entire space is completed and the overall cleaning is completed before completely peeling off the protective film. When tearing off the protective film, first slowly pull up the protective film on the four sides, and then slowly tear off the protective film from any side. During the tearing process, do not use instantaneous or local force to avoid uneven force from sticking off the pattern protective layer on the product surface.
What are the key points in designing ceramic tile background walls?
1. Unpack the package, and when moving a single piece, be careful not to scratch the patterns on other brick surfaces with the corners of the bricks.
2. Products must be placed vertically before and after unpacking, and should not be placed flat.
3. When moving single pieces, try to avoid friction between the two bricks, even if the surface is covered with a protective film.
4. Tear off the protective filmWhen tearing, first slowly pull up the protective film on the four sides, and then slowly tear off the protective film from any side. During tearing, do not use instantaneous or local force to avoid uneven force and the pattern on the surface of the product will be stuck off. protective layer.
5. Do not remove the protective film before installation.
6. If you need to knock the product when paving, you need to use a wooden board to pad the surface. Do not directly tap the brick surface with paving tools.
7. Putty: After all the tiles are installed on the wall, putty will be applied. This is similar to the normal laying of ceramic tiles. The workers are applying putty to the inverted groove part.
8. Finished effect: Take a look at the finished TV background wall. By the way, don’t forget to make holes where the TV lines are reserved.
The above is the content about tile background wall that I talked about today. Don’t tell me that I can do it once I see it, but it will be useless once I do it. Hahahaha, Zhongtao Jun is gone first!
